BRAKE FLUID is a grey area for the home maintenance person. What many donít understand is it, like methanol, attracts water.

Itís hygroscopic. So when you get into the engine bay of your old car and you find the underside of the master cylinder lid is rusty or corroded, itís because of this.

When you drive the car, the water in the lines will get hot and may even boil. It does this at a much lower temperature than brake fluid, which isnít good. Itís advisable to change the fluid at worst once every three years. You can test it Ė but weíll get onto that in a moment.

People get scared of bleeding brakes, but itís not a difficult task. Youíre trying to achieve a couple of things: refresh the fluid, and remove any air bubbles, as air compresses easily and will make your spongy pedal worse.

The first step is to pull the old fluid out of the master cylinder. You can do this ideally with a syringe, though it can simply be soaked up with a rag (but donít let it drip on painted surfaces!). Do this until itís dry, wipe out any crud and crustaceans, then top it up with a freshlyopened container of fluid.

Donít use the one youíve had sitting half empty on the shelf for months or years, as that defeats the entire purpose of the exercise. Keep the container handy, as youíll be topping up as you go.

The easiest way to bleed brakes on your own is first to leave the lid off the master cylinder. Then go to the furthest bleed nipple Ė usually at the rear, on the opposite side to the master cylinder. Open it up and let Mother Nature take over.

Gravity will roll fresh fluid through. Use a hose and container to collect it and leave it open until you see fresh fluid coming through.

So long as you donít touch the brake pedal, you wonít pull air back into the system.

Close that one off, top up the master cylinder and go to the next furthest away. Repeat the process until all the wheels are done. This takes time, but it works.

With a friend on hand there are quicker method options.

Brake fluids are a bit of a minefield, as there are lots of options out there. The best rule of thumb is to stay with the older DOT 3 or 4 on older cars. And donít mix up fluid types. Under no circumstances should you put silicon fluid in your older car Ė it just wonít be compatible with the seals and hoses and you will end up with a complete disaster.

One tool we use in the trade, thatís become much cheaper as time has gone by, is a brake fluid tester. Itís an electronic machine with two probes and gives you an indicator of when itís time to lose the fluid. Itís a great little gadget to have in the toolbox.

Happy braking!